C-24.2, r. 32 - Regulation respecting safety standards for road vehicles

Schedule Disposition versions

2016-11-20

SCHEDULE VI

List 4 – Motor Coach (inspection every 30 days or 12,000 km)

Application :
This list applies to a motor coach.
Note :
	• All the defects described in this list constitute major defects that must be repaired before the vehicle may be used again.
	• Inspections under list 4 must be made while the vehicle is placed above a pit or elevated to facilitate inspection.
1.	Frame and cargo body
	1.A	Structural members missing, insecure, cracked, broken, bent or inadequate
2.	Steering
	2.A	Steering or self-steering axle component missing, damaged, insecure or inadequate
	2.B	Fluid leak other than a slight oozing
3.	Tires
	3.A	Inadequate air pressure
	3.B	Tire groove that reached the wear limit
	3.C	Tire tread or sidewall damaged or foreign material that could cause a puncture stuck in the tread or in the sidewall
	3.D	Tire tread recapped mounted on the active steering axle
4.	Emergency exits, seatbelts and seats
	4.A	Roof emergency exit fails to open adequately
	4.B	Emergency window fails to open and close without difficulty or warning light or buzzer is inadequate
	4.C	Seatbelt is missing, damaged, modified, insecure or inadequate
	4.D	Seat or bench seat not securely attached
5.	Wheels and fasteners
	5.A	Fastener missing, insecure, cracked, broken, damaged, repaired with welds or inadequate
	5.B	Wheel damaged, cracked, broken, repaired or welded
	5.C	Wheel bearing makes abnormal noise, shows wear signs and leakage of the lubricant other than oozing or lubricant is below the minimum level
6.	Suspension
	6.A	Suspension component missing, insecure, deteriorated or inadequate or air leak in lines and system components
	6.B	Component for mounting the axle or positioning the axle or wheel that is missing, cracked, broken, insecure, displaced, bent or repaired with welds
	6.C	Axle cracked, warped, repaired with welds, misaligned or not perpendicular to the vehicle's lengthwise axis
	6.D	Lines or fittings insecure, damaged or inadequate
	6.E	Ball insecurely mounted on the structure, shows repair or so damaged that the cord is exposed
	6.F	Shock absorber or bracket missing, inadequate, insecure, cracked or broken
	6.G	Shock absorbers leaking in a way that hampers their performance
7.	Fuel system
	7.A	Fuel leak
	7.B	Fuel tank cracked or fuel tank fixing component missing, insecure, cracked, broken or inadequate
	7.C	Lines or fittings insecure, damaged or inadequate
8.	Exhaust system
	8.A	Exhaust system component insecure or leaking
9.	Pneumatic brake system
	9.A	Audible air leak
	9.B	Pushrod stroke exceeds the adjustment limit or the variation in the travel of the actuating rods on a single axle exceeds 6.4 mm
	9.C	Brake linings poorly adjusted
	9.D	Air compressor insecure or whose pulley is cracked or broken
	9.E	Belt of air compressor is cut or whose tension is inadequate
	9.F	Lines or fittings insecure, damaged or inadequate
	9.G	Air reservoir insecure, damaged or inadequate
	9.H	Drain tap missing or inadequate
	9.I	Service, parking or emergency brake not operating properly
Specific inspections required by the operator

O.C. 370-2016, s. 109.